 | |
 | How to use this learning unit |
|
 | |
 | |
 | |
 | Enable Acceleration Control menu |
|
 | |
 | Build Plate Adhesion menue |
|
© 2018 ITB Bremen, Nachwuchsstiftung Maschinenbau gGmbH, Bielefeld, Germany
This project has been funded with support from the European Commission. This publication [communication] reflects the views only of the author, and the Commission cannot be held responsible for any use which may be made of the information contained therein.
Line Width
Width of a single line. Generally, the width of each line should correspond to the width of the nozzle. However, slightly reducing this value could produce better prints.
Affects:
- Wall Line Width, Inner Wall(s)
Line Width
- Top/Bottom Line Width, Infill Line Width
- Skirt/Brim Line Width, Support
Line Width
- Support Interface Line Width
- Prime Tower Line Width, Raft Top Line Width
Affected by:
Nozzle Diameter
Here you see the menu for "Quality". These settings are responsible for the quality of the entire printing process.
Layer Height
The height of each layer in mm. Higher values produce faster prints in lower resolution, lower values produce slower prints in higher resolution.
Affects
- Top Layers
- Bottom Layers
- Infill Layer Thickness
- Minimum Skin Width for Expansion
- Regular Fan Speed at Layer
- Support Infill Layer Thickness
- Raft Top Layer Thickness
- Prime Tower Thickness